SIIG CyberSerial Dual PCI Instalační příručka

1CyberSerial Dual PCIQuick Installation Guide04-0375CIntroducing the CyberSerial Dual PCIThe CyberSerial Dual PCI high-speed serial I/O cardprovides

104. Edit the startup file and add these two commandlines at end of the startup file.- setserial /dev/ttyS2 port 0xa000 irq 9 uart 16950.- setserial /

11Technical Support and WarrantyQUESTIONS? SIIG’s Online Support has answers! Simply visit ourweb site at www.siig.com and click Support. Our onlin

CyberSerial Dual PCI is a trademark of SIIG, Inc. SIIG and the SIIG logo are registered trademarks ofSIIG, Inc. Microsoft, Windows and Windows Vista

2Package Contents• CyberSerial Dual PCI board• Driver CD• Quick installation guideLayoutFigure 1. LayoutJumper Settings (JP1, JP2)Open = 0 volts (def

3Hardware InstallationGeneral instructions for installing the card are providedbelow. Since the design of computer cases andmotherboards vary, refer

4Driver InstallationThis section provides information on how to install theCyberSerial Dual PCI drivers.Windows 7 (32-/64-bit)1. Right click Computer,

53. Repeat step 2 to complete the driver installation.Note: Windows Vista driver installation processmay take several minutes to complete.Windows XP (

6Windows 20001. At the Found New Hardware Wizard, click Next.2. Select Search for a suitable driver for my device(recommended), then click Next.3. Che

7Windows ME1. At the Add New Hardware Wizard, select Specifythe location of the driver (Advanced), click Next.2. Insert the driver CD, check Specify a

84. From the Insert Disk window, click OK. When theCopying Files dialog box pops up, type in D:\9x,then click OK. (Change D: to match your CD/DVD-ROM

9DOS1. Boot up DOS and insert the driver CD.2. Copy OXSER.EXE from the DOS folder to your C:drive.3. At the C: prompt, type in OXSER io=3e8 and theser