SIIG II-150 Uživatelský manuál

1SATA II-150 PCIQuick Installation GuideIntroducing the SATA II-150 PCIThe SATA II-150 PCI is an ultra high-speed dual channelSerial ATA Generation 2

10Existing Windows 2008 Installation1. Install the board and boot up Windows.2. At the Found New Hardware Wizard, insert thedriver CD, select Locate a

11Technical Support and WarrantyQUESTIONS? SIIG’s Online Support has answers! Simply visit ourweb site at www.siig.com and click Support. Our onlin

SATA II-150 PCI is a trademark of SIIG, Inc. SIIG and the SIIG logo are registered trademarks of SIIG,Inc. Microsoft, Windows and Windows Vista are

2System Requirements• Pentium® or equivalent PC with an available PCIslot• Windows® 2000 / XP (32-/64-bit) / Server 2003 &2008 (32-/64-bit) / Vist

3Hardware InstallationNote: For low profile systems, replace the currentlymounted bracket with the included low profile bracket.General instructions

4Driver InstallationThis section provides information on how to install theSATA II-150 PCI drivers for the following operatingsystems.Windows 2000New

55. Click Yes, then click Finish.6. Restart Windows to complete the driver installation.Windows XP/Server 2003New Windows XP/Server 2003 InstallationA

63. Insert the driver CD, select Install the softwareautomatically (Recommended), then click Next,Next.4. Click Continue Anyway, then click Finish.5.

7Existing Windows Vista Installation1. Install the board and boot up Windows.2. At the Found New Hardware Wizard, insert thedriver CD, select Locate a

84. Remove the driver CD and restart Windows tocomplete the installation.To Verify Windows Vista Installation1. Right click Computer, click Manage, cl

94. Click Browse my computer for driver software(Advanced).5. Type in D:\Vista32, (change D: to matchyour CD-ROM drive letter), then click Next.6. C