SIIG UltraATA 133 PCI Instalační příručka

1UltraATA 133 PCIQuick Installation Guide04-0233FIntroducing the UltraATA 133 PCIThe UltraATA 133 PCI is an ultra high-speed dual channelUltra ATA/133

10For Existing 32-bit Windows XP/Server 2003 Installation1. Install the board and boot up Windows.2. At the Found New Hardware Wizard.XP (w/SP1 or ear

11For Existing 64-bit Windows XP/Server 2003 Installation1. Install the board and boot up Windows.2. At the Found New Hardware Wizard:XP (w/SP1 or ear

124. Insert driver CD, then click Browse5. Double click CD Drive (D:), (change D: to matchCD-ROM)6. Highlight 32bit folder, then click OK7. Select Sil

137. Select Silicon Image SiI 0680 ATA/133 Controller(D:\64bit\AMD64\SI680.inf), then click Next8. Follow on-screen instructions to complete WindowsVi

14Blank Page

15Technical Support and WarrantyQUESTIONS? SIIG’s Online Support has answers! Simply visit ourweb site at www.siig.com and click Support. Our onlin

UltraATA 133 PCI is a trademark of SIIG, Inc. SIIG and the SIIG logo are registered trademarks of SIIG,Inc. Microsoft and Windows are registered tra

2Package Contents• UltraATA 133 PCI adapter• Driver CD• 40-pin/80-wire Ultra ATA cable• Quick Installation GuideLayoutIDE1IDE2Jumper On(do not remove)

31. Turn OFF the power to your computer and anyother connected peripheral devices.2. Unplug the power cord from the back of thecomputer.3. Remove your

43. When two drives are installed on the same IDEchannel, make sure one drive is set up as Master andthe other as Slave. This rule applies to both ID

52. Once Windows has been installed, right click MyComputer and click Properties. Select DeviceManager tab.3. Double click PCI Mass Storage Controll

62. Once Windows has been installed, right click MyComputer, then click Properties. Select DeviceManager tab.3. Double click PCI Mass Storage Control

7Windows NT 4.0For New Windows NT 4.0 InstallationA new installation of Windows NT 4.0 requires a floppydisk for the driver installation. To make thi

87. Remove the driver CD. Restart Windows tocomplete the driver installation.To Verify Windows NT 4.0 Installation1. Double click My Computer/Control

9For Existing Windows 2000 Installation1. Install the board and boot up Windows 2000.2. At the Found New Hardware Wizard, click Next3. Select Search f