SIIG RS-232 to Multi-Mode Fiber Optic Instalační příručka

1FiberOptic SwitchesQuick Installation GuideThis quick installation guide provides instructions for installing aFiberOptic Switch.1-1 Introducing the

104-1 Technical Support & RMAQuestions? SIIG’s On-line Support has the answers! Simply visitour web site at www.siig.com and click on the ON-LI

2• Network Interface:Models:4000-ST : Four 100Base-FX, ST (multi-mode)4000-SC: Four 100Base-FX, SC (multi-mode)4000-MT: Four 100Base-FX, MT-RJ (multi-

3Maximum Fiber Optic Cable LengthsTo help ensure a successful installation, you must observe the followingcabling parameter. Violating these rules can

42-1 Hardware InstallationThe following figures identify the front panel port, DIP switch and LEDlocations for the FiberOptic Switch models. Please re

52-1.1 Fiber Port Full-/Half-duplex Mode ConfigurationEach fiber port can be independently configured for either full-duplex(FDX) or half-duplex (HDX)

6NOTE FOR MODELS 8020-ST/SC: The fiber port can be up-linkedto an upper level hub's port. You may use the "1/MPR" port toup-link the hu

7Multiple Hubs Cascading and Long-Haul Connection3-1 TroubleshootingNetwork troubleshooting requires patience and logic. Generallyspeaking, the cablin

83-1.2 Workstation ProblemsMost non-cabling problems result from improper configuration of thenetwork interface card (NIC) and its corresponding drive

93-1.3 Other ProblemsOther specific problems may be diagnosed by using the LEDs, as below.Power LED is off when the AC Power switch is ON:• Defective