SIIG RS-232 to Bluetooth Instalační příručka

1RS-232 Serial to BluetoothAdapterQuick Installation Guide04-0775AIntroductionThe RS-232 Serial to Bluetooth Adapter is designedto easily allow any RS

103. DTE & DCE Switch.Use the DTE/DCE Switch to swap betweenDTE/DCE. By switching, you can set theadapter as a DTE (towards antennaconnector) or a

11Type DIP=Y to turn on the function of theDIP switch.After the function of DIP switch has turnedon, you can adjust the switch to "G".5. Set

12ADDRESS= Used to display the Bluetooth address of the local adaptor.? Inquire the Bluetooth address of the local adaptor.ATCheck the connection stat

13CONNECT=Used to establish a connection manually. It is available onlywhen the adaptor is in the master role.DEVI-CEConnect the adapter to a specifie

14RRestore the status so the adaptor can connect with any remoteaddress.?Inquire the designated address that can be paired andconnected.DIP= Set the D

15NAME=Used to specify a name for the adapter.You can specify a name by using 0 to 9, A to Z, a to z, spaceand -. (Note: Using Space or - as first or

16(Default) Y Prompt result messages.N Don't prompt result messages.? Inquire the current setting.RECONNE-CT=Used to re-connect the lost link for

17STOP=Used to specify one or two stop bits of COM port. (Will have200ms delay.)(Default) 1 One stop bit.2Two stop bits.? Inquire the current setting.

186. RS232 Interface6.1. Pin-out7. DSR/DTR Connection6.2. SignalsPin Signal DTEDirectionDCEDirectionDescription1 CD Input Output Not connected2 TxD

19Technical Support and WarrantyQUESTIONS? SIIG’s Online Support has answers! Simply visit our web site atwww.siig.com and click Support. Our onli

2Package Contents• RS-232 Serial to Bluetooth Adapter• External Dipole Antenna• USB Cable• Battery power line and connector• Quick installation guideL

PRODUCT NAMERS-232 Serial to Bluetooth AdapterFCC RULES: TESTED TO COMPLY WITH FCC PART 15, CLASS BOPERATING ENVIRONMENT: FOR HOME OR OFFICE USEFCC CO

3LED IndicatorsSee Figure 1 for the location of the LEDs.Please refer to the following chart for the status ofLEDs.Status DescriptionPower LED off/ on

4Figure3RS-232 (Serial)Connect the RS-232 port into any computer orserial device, see Figure 3.ApplicationsOne to oneWith Bluetooth USB DongleBluetoot

5Reset ButtonUse a tip of a pen or other sharp object to accessthe reset button.• To restore to factory default settings: pressand hold down the reset

6Hardware Installation1. Fasten the antenna to the adapter andconnect it to serial port of the PC.2. Power on.2.1. Plug the included mini USB connect

7COM Port Configuration Guide1. Configure the parameters of the COM port.1.1. Enter Hyper terminal or other terminalsoftware to configure the adapter

81.3. Scroll to the COM port you are using toconnect, and click OK.1.4. Confirm the parameters as thefollowing, to pair two devices for anexclusive

92. Set up the slave / master mode.This is for identifying the role of the deviceas a master or slave.Select Master, for DTE mode, for DataTerminal Eq