SIIG Low Profile USB 2.0 Instalační příručka stáhnout pdf (Strana 4)

Windows ME/2000

Note: If you have Windows 2000 with Service Pack

4 (SP4) or later, the drivers will be installed

automatically by the operating system. Otherwise,

follow the instructions below.

1. Install the board and boot up your system. At the

Add New Hardware Wizard, click Cancel.

2. Insert the driver diskette. Click Start, Run, type in

A:\setup.exe, then click OK.

3. Choose Yes, I will restart my computer now,

remove the driver diskette, then click Close.

4. When Windows resumes, the drivers install

automatically.

5. The board is now ready for use.

Windows XP

Note: If you have Windows XP with Service Pack 1

(SP1) or later, the drivers will be installed

automatically by the operating system. Otherwise,

follow the instructions below.

1. After installing the board, boot up to Windows. At

the Found New Hardware Wizard, click Cancel.

2. Click Start, Run, insert the driver diskette, type

A:\setup.exe, then click OK.

3. At the Software Installation window click Continue

Anyway. Our driver has been thoroughly tested in

Windows for stability.

4. Choose Yes, I will restart my computer now, remove

the driver diskette, then click Close.

1 2 3 4 5 6 7 8

Žádné komentáře

SIIG Low Profile USB 2.0 Instalační příručka Strana 4