SIIG Serial ATA PCI Instalační příručka stáhnout pdf (Strana 4)

Figure 3. Connecting the Serial ATA cable

5. Follow the same instructions when connecting a

second hard drive. Device connection is now

complete.

6. Close the computer's case then go to Software

Installation to complete the Serial ATA PCI-M

installation.

Software Installation

Mac OSX (v10.2.x) or later drivers are built into the

controller's firmware, no additional driver installation or

firmware update are needed. Go to Mac OS X Installation

on page 5 to complete the installation.

In order for the controller to work in Mac OS X v10.1.x, the

firmware must be updated using the utility on the driver

CD. Go to Mac OS X (v10.1.x) Firmware Update below.

Mac OS X (v10.1.x) Firmware Update

Before installing the update please follow these

guidelines:

• Make sure no drives are connected to the Serial ATA

PCI-M

• This utility can only be used in Mac OS X v10.1.x

Serial ATA cable

1 2 3 4 5 6 7 8

Žádné komentáře

SIIG Serial ATA PCI Instalační příručka Strana 4