SIIG I/O Expander 2S Uživatelský manuál

3-1Hardware InstallationREMEMBER: the same COM port address or IRQsetting CANNOT be used by more than one port inyour system. Each port assignment mus

3-10I/O Expander 4S User's ManualU6U7U8460800 U53F8 COM12F8 COM23E8 COM32E8 COM42F0 COM53E0 COM62E0 COM7260 COM8368 COM9268 CO

3-11Hardware InstallationInterruptInterruptInterruptInterruptInterruptRequestRequestRequestRequestRequestBaudBaudBaudBaudBaudRateRateRateRateRateCOMCO

3-12I/O Expander 4S User's Manual6. To install the connector bracket, carefully slide it intothe selected rear panel slot where the slot cover ha

3-13Hardware InstallationIMPORTANT NOTE: The colored stripe imprintedon the ribbon cable indicates the pin 1 side of thecable’s connector. Make sure

3-2I/O Expander 4S User's Manual COM Port COM Port COM Port COM Port COM Port I/O Addr I/O Addr I/O Addr I/O Addr I/O AddrJumper SettingJumper Se

3-3Hardware Installation COM1 COM28 COM38 COM4 COM50 COM60 COM70 COM88 COM98 COM100 COM110 COM123-2.2 COM Port Address SelectionCOM PortCO

3-4I/O Expander 4S User's Manual3-2.3 Interrupt Request (IRQ) SelectionSerial Port 1Serial Port 1Serial Port 1Serial Port 1Serial Port 1 is fact

3-5Hardware InstallationIRQ3IRQ4IRQ5IRQ7IRQ9IRQ10IRQ11IRQ12IRQ15IRQ15Disable (all open)Interrupt RequestInterrupt RequestInterrupt RequestInterrupt Re

3-6I/O Expander 4S User's ManualBaud RateBaud RateBaud RateBaud RateBaud Rate Jumper Setting Jumper Setting Jumper

3-7Hardware InstallationWARNING: Disconnect the AC power sourceWARNING: Disconnect the AC power sourceWARNING: Disconnect the AC power sourceWARNING:

3-8I/O Expander 4S User's ManualNOTE: Hold the card by its external edges only. Try to Hold the card by its external edges only. Try to Hold the

3-9Hardware InstallationIf the ports are not recognized, please review theinstallation procedures. For further help, contact SIIG'sBBS and/or te