SIIG UltraATA 133 PCI Instalační příručka

1UltraATA 133 PCI RAIDQuick Installation Guide04-0234AIntroducing the UltraATA 133 PCI RAIDThe UltraATA 133 PCI RAID is a ultra high-speed dual channe

10Combination RAID Setup ModesStripe * Mirror: Set up one Stripe set and one Mirror set. Connectthe drive pair to seperate IDE channels. The two har

113. Select Set RAID Mode, press Enter.4. Select Mirror * Stripe, then press Enter.5. Select stripe size then press Enter.6. Press Y to save y

12Software InstallationThis section provides information on how to install the UltraATA 133PCI RAID drivers for the following operating systems:New &a

136. Remove the Driver diskette and restart Windows to completedriver installation.Windows ME Driver InstallationFor New Windows ME Systems1. Afte

143. Highlight SIIG CN2496 PCI Ultra ATA 133 RAID Adapterand click Properties. A message This device is working properlyis displayed in the dialog b

15Windows 2000 Driver InstallationFor New Windows 2000 Systems1. After the UltraATA 133 PCI RAID and attached drives areconfigured, follow Microsoft

163. Insert the Driver diskette. Press S then press Enter.4. Select SIIG CN2496 ATA 133 RAID WinXP Miniport Driverand press Enter.5. Press Enter

17Technical SupportQUESTIONS? SIIG’s Online Support has the answers! Simplyvisit our web site at www.siig.com and click Support/Drivers.Our online

PRODUCT NAME MODEL NUMBER UltraATA 133 PCI RAID CN2496FCC RULES: TESTED TO COMPLY WITH FCC PART 15, CLASS BOPERATING ENVIRONMENT: FOR HOME

2Package Contents• UltraATA 133 PCI RAID board• Two 40-pin/80-wire Ultra ATA cables• Two power supply "Y" split cables• One driver d

3Device ConnectionThe UltraATA 133 PCI RAID is a dual channel Ultra ATA/133controller that adds RAID support for up to four IDE hard drives.In order

4BIOS ConfigurationThe UltraATA 133 PCI RAID BIOS will appear everytime yoursystem starts up. If the bios doesn't show, please try your contro

5Raid 0 Setup ModesStripe (4 Drives): Set up 3 or 4 hard drives into a singleStripe set.Stripe * Stripe: Set up one or two independent Stripe sets.C

66. Press Y to save your settings.7. Do you want to erase disk window appears. Press Y, selectdisk and press Enter. Press Y to confirm. Press ESC

7configurations, however it's also possible to combine hard drives ofdifferent sizes and makes. In a mirror set, when combining harddrives of di

8 (source) hard drive to IDE1, then attach your blank hard driveto IDE2. Make sure both drives are attached to the endconnector of the Ultra ATA

95. At the warning message press Y to Build Mirror Disk.6. After mirror rebuilds, press any key to continue.7. Press ESC, ESC, select Update Dat