SIIG UltraATA 133 PCI Instalační příručka stáhnout pdf (Strana 7)

configurations, however it's also possible to combine hard drives of

different sizes and makes. In a mirror set, when combining hard

drives of different sizes the total mirror set size will be the size of the

smallest hard drive.

Raid 1 (Mirror) Setup Mode

Mirror * Mirror: Set up two independent Mirror sets. Connect

the drive pair to seperate IDE channels then follow Device

Connection for correct setup. The two hard drives set up as

master is the Master mirror set. The hard drives set up as slave

become the Slave mirror set. The Master mirror set is bootable.

Raid 1 (Mirror) Setup

With two or four blank hard drives attached:

1. Install the UltraATA 133 PCI RAID and attach your hard

drives.

a. For two blank hard drives: Attach one hard drive to IDE1

and the other hard drive to IDE2. Make sure both drives

are set up as Master.

b. For four blank hard drives: Follow directions on page 3,

Device Connections, to connect your hard drives.

2. Start the computer. When prompted by the RAID BIOS, press

F1 to enter the raid bios setup.

3. Select Set RAID Mode, press Enter.

4. Select Mirror * Mirror, then press Enter.

5. Press Y to save your settings.

6. Do you want to erase disk window appears. Press Y, select

disk and press Enter. Press Y to confirm. Press ESC when

finished to reboot the computer.

7. Continue with conventional Fdisk and Format steps as if you

are installing a conventional hard drive.

8. Your RAID configuration is complete. Please proceed to

Software Installation section.

Mirroring an Existing Hard Drive

1. Install the UltraATA 133 PCI RAID and attach your hard

drives.

a. Mirroring one existing hard drive: Attach your existing

1 2 3 4 5 6 7 8 9 10 11 12 ... 17 18

Žádné komentáře

SIIG UltraATA 133 PCI Instalační příručka Strana 7